Page 1 of 1

New vector capability with Track IR2?

Posted: Tue Dec 07, 2004 4:58 pm
by jettaguy
Is there anyway to upgrade my track IR2 to take advantage of this new enhancement or do I need to buy a whole new IR3 unit?

Re: New vector capability with Track IR2?

Posted: Wed Dec 08, 2004 9:31 am
by MrGnome
I don't understand why, but it seems it's only possible with TrackIR3

http://forums.naturalpoint.com/cgi-bin/ ... 2;t=000007

Re: New vector capability with Track IR2?

Posted: Thu Dec 09, 2004 4:47 am
by Charlie251
Once again, as can be read in the link you posted right there above......

From Jim:

There is a technical reason that we can't make the TIR1 or 2 work with Vector. It is in both the imager and the lens, both are different from the TIR3. The whole system is designed to work together as a single piece, so we chose the TIR3 as the base platform and all the calculations are based on that imager and lens combo. The TIR1/2 would work with the same math and vector clip in addition to it not being precise enough for good tracking quality. I hope that info helps.
--------------------
Jim

NaturalPoint

Re: New vector capability with Track IR2?

Posted: Fri Dec 10, 2004 12:56 pm
by MrGnome
Yes Charlie, thanx Jim for finally providing an answer to this. Jim's answer was not in the forum when i posted the link above. That's why i still was puzzled at that time to why it "did not work".

[ December 10, 2004, 07:57 PM: Message edited by: MrGnome ]