Probe Calibration Progress Bar Not Filling Up
Posted: Sat Jan 28, 2023 8:59 am
Hello,
I'm currently trying to pivot calibrate the tip of a probe / rigid body in Motive 2.1.1 using an Duo tracking bar. Motive will prompt me to pivot the probe but the progress bar never fills up. What's the issue?
Thanks in advance!
I'm currently trying to pivot calibrate the tip of a probe / rigid body in Motive 2.1.1 using an Duo tracking bar. Motive will prompt me to pivot the probe but the progress bar never fills up. What's the issue?
Thanks in advance!