Page 1 of 1

Realtime data and NatNet

Posted: Mon May 05, 2025 12:41 am
by jesse930
I'm using the Rigid Body toolkit to generate the location of one rigid body. I then stream that data using NatNet.
On the same PC I am running the NatNet client and I can receive the streaming data and display it on screen.
However after about two minutes I notice a lag between the motion of the rigid body and the displayed data.
Is there some data buffering occuring? Do I need to set up some handshaking?

Re: Realtime data and NatNet

Posted: Fri May 16, 2025 7:10 pm
by Lyly19
You may be experiencing buffer buildup over time—I had this problem with NatNet. Try disabling "Multicast" or making sure the client is processing data in real-time thread priority. Also, check that the client application is processing fast enough so that it doesn't slow down over time!