Page 1 of 1

Help please.

Posted: Sat Sep 17, 2005 3:03 pm
by Clayp
I have an original TIR.All of the manuals I find on the site dont match the software ver 3.13.Iam having trouble getting it to center up I think.When I look around with TIR on I can look behind me to my left but not to the right.I'm not real bright so please make the answer simple.....

Re: Help please.

Posted: Sat Sep 17, 2005 6:10 pm
by rodom
What's the serial number of your unit? I can also get the manual to you if you want for 3.13. I can just zip it up for you and e-mail it.

Re: Help please.

Posted: Sun Sep 18, 2005 2:06 am
by Clayp
Thanks for the answer sir..The ser # is hard to read.Could be either..005909 or 005808..Sorry these are old eyes...Could yoy send that manual when you have a min.... skalb@socal.rr.com Thank you very much.....

P.S In your opinion sir am I useing the right software for this unit? If not what one should I use and where do I get it? Thanks again..

[ September 18, 2005, 09:14 AM: Message edited by: Clayp ]

Re: Help please.

Posted: Sun Sep 18, 2005 8:57 am
by Birch
Also, for anyone else that might be intersted in it, the TrackIR Software version 3.xx manual (and software) is available from the TrackIR website in the support section :

http://www.naturalpoint.com/trackir/06- ... -and-manua ls-v3.html

[ September 18, 2005, 03:59 PM: Message edited by: NaturalPoint - Birch Zimmer ]

Re: Help please.

Posted: Sun Sep 18, 2005 11:55 am
by rodom
By looking at that serial number I believe those are the right drivers. I will double check when I get into the office tomorrow.

Thanks for the link birch. I spaced out and forgot it was online as well.

Re: Help please.

Posted: Sun Sep 18, 2005 1:26 pm
by Clayp
Well I dont know what to say..I went to the link supplied for the manual and it dosent match the software for the 3.13 driver...I'm sorry for having caused any trouble for you all.I will just do without TIR..I cant get it adjusted where it works anyway..Thanks again..

Re: Help please.

Posted: Mon Sep 19, 2005 7:18 am
by rodom
The link was incorrectly sending people to the new manual PDF file. It has been fixed now and will show the older manual for the 3.XX software.

Re: Help please.

Posted: Mon Sep 19, 2005 9:32 am
by Clayp
Thank you....