TrackClip Pro into USB 2.0 = not hi-speed??
Posted: Fri Jul 06, 2007 4:40 pm
Hi,
First I just want to say that I received TrackIR yesterday and I love it already.
I do have a small problem... when I plug the TrackIR + Clip into a USB port on my PC I get the following message:
"hi-speed device attached to non hi-speed hub".
As far as I know, ALL of the USB ports on my motherboard are 2.0
(EVGA 122-CK-NF68-A1 LGA 775 NVIDIA nForce 680i SLI ATX Intel Motherboard)
I did try all of the ports, all give me the same message.
The ONLY way to avoid getting the message is to plug TrackIR + Clip into a USB on my monitor (Dell 2007WFP) which is still going to the same place anyway so I don't get why it works this way.
I did try plugging TrackIR into the same port that the monitor was originally going to and got the message. Like I said, I tried all of the ports.
Any insight would be greatly appreciated!
btw, TrackClip is plugged into TrackIR via the Power Tap.
First I just want to say that I received TrackIR yesterday and I love it already.
I do have a small problem... when I plug the TrackIR + Clip into a USB port on my PC I get the following message:
"hi-speed device attached to non hi-speed hub".
As far as I know, ALL of the USB ports on my motherboard are 2.0
(EVGA 122-CK-NF68-A1 LGA 775 NVIDIA nForce 680i SLI ATX Intel Motherboard)
I did try all of the ports, all give me the same message.
The ONLY way to avoid getting the message is to plug TrackIR + Clip into a USB on my monitor (Dell 2007WFP) which is still going to the same place anyway so I don't get why it works this way.
I did try plugging TrackIR into the same port that the monitor was originally going to and got the message. Like I said, I tried all of the ports.
Any insight would be greatly appreciated!
btw, TrackClip is plugged into TrackIR via the Power Tap.