forums.naturalpoint.com

Hello,

I run the Point Cloud Calibration Tool many times and it sometimes hangs in the Wand and Result. It happens when suddenly appear many marks on the capturing volume. First time I noticed was with 3 cameras placed next to each other (15cm of separation each), with the corner ones pointing inward. Then I placed many small reflective markers near the cameras. That made the application hang.

After that, if I try to close the application the camera shutdown progress bar appears, but never ends. The only way to end the program is then via the Task Manager.

Is that a problem with the application or is there an stability problem within the API?

Thanks in advance.

Hi, txemi.

In the current version of the software it is possible to overload a medium performance machine by putting your hand, for example, right over the lens because you will generate a very large amount of objects that are then pushed down from the camera and overload the CPU.

My advice is to not put objects immediately in front of the cameras until you've adjusted the camera settings to prevent this situation.

Upcoming versions have additional safeguards in place for overload conditions.

Thanks