Page 1 of 1
How many axes in PPJoy?
Posted: Tue Oct 30, 2007 9:48 am
by Jabberwock
Did anyone manage to make PPJoy to work with all six axes? My TIR shows six axes, but PPJoy joystick shows only two...
Re: How many axes in PPJoy?
Posted: Tue Oct 30, 2007 11:40 am
by VincentG
Currently I believe that the PPJoy software itself only supports 2 axes.....
Re: How many axes in PPJoy?
Posted: Tue Oct 30, 2007 12:39 pm
by Jabberwock
Well, I got it right, finally.
It seems that I had setup the "interface type" with two axes. After that nothing I did (either with "mapping the controller" or "interface type") was able to change that.
I had to delete the whole interface type configuration and set a new one, with the proper number of axes. Then I had to repeat the configuration for the particular joystick. Only after that I was able to see all six axes working properly...
Re: How many axes in PPJoy?
Posted: Tue Oct 30, 2007 2:31 pm
by VincentG
OK...