forums.naturalpoint.com

I noticed if I use the TrackClip PRO (with TIR4) if I turn my head 180 degrees in CFS3, the on screen head turns fine, and recenters OK if I look back to front view. However if I turn my 'real' head too far, say 190 200 degrees, then it does not recenter when I turn back to the front view, and the on screen head is still looking at 2 oclock.

This seems to be a bug because if I then turn my head right around the opposite direction and look right back then come back to center it's recentred again automatically. It's like the TIR4 registers I moved 200 degrees but only turns back 180.

Any ideas?

BTW I have it on the monitor, and slightly off center as mentioned instructions - it works fine otherwise.

looking at the tracking screen, just the 3 green, no red?

Hi yes sorry I took so long to come back Vincent. Yes, I have moved it much further away and it works better, but I thought the whole point of the clip and TIR4 was you could use in on your monitor - closer than TIR3. Anyway its OK now so thanks.