Page 1 of 1
Un steady view
Posted: Mon Feb 04, 2008 11:48 am
by jsearl98
When I steady my head, the view wanders up and down slightly around the fixed point. This makes it difficult to click-on switches etc. How do I stop this? I can see the relevant gauges wandering slightly when I go into edit but I cant seem to edit this movement out. Any ideas?
Re: Un steady view
Posted: Mon Feb 04, 2008 12:01 pm
by VincentG
You can do this several ways -
1 - Setup a deadzone, within the profiles so that it takes a larger movement before the view is affected.
2 - Some customers pause the software, before they adjust knobs, switches, etc.
Re: Un steady view
Posted: Mon Feb 04, 2008 12:07 pm
by jsearl98
Thanks. I will try both strategies and get back.
Re: Un steady view
Posted: Mon Feb 04, 2008 12:09 pm
by VincentG
OK.......