forums.naturalpoint.com

Hello,

I'm working with 2 Flex:V100 cameras but I'm thinking in use for the next proyects the SLIM models, but i've got a little problem; how can I synchronize them? Could anybody send me a photo of the conector? I've read in the FAQ that there are a pin for every functions, I need to make a special conector? Can I buy then?

Thanks a lot!

Hello:

Good question. There is a .1" header on the side of the SLIM, it has the sync connections on it. You would have to make a cable to connect the .1" header to other cameras. .1" headers are pretty common, you should be able to get them anywhere. The header on the camera is Female and comes out the back side.

hello again,

this morning the SLIM camera has arrived at my office and now i can see the connector; do you know the part-number of the male connector from MOLEX or another manufacturer that could work properly with the camera?

Thanks a lot

Hello:

Sure, it is actually a 2mm header, not .1".

Something like this should work:
http://www.samtec.com/technical_specifi ... D_PRODUCTS

Any Digikey 2mm male header will work. I usually get them in a long strip and cut them to length (for the right number of pins I want to use)