Page 1 of 1
MotionBuilder
Posted: Thu Apr 10, 2008 12:09 pm
by fxrtst
I cannot remember if I have asked this before, can I run Optitrack and stream to Motionbuilder on the same machine live or recorded?
Thanks,
Will
Re: MotionBuilder
Posted: Thu Apr 10, 2008 12:29 pm
by VincentG
Yep, it can be done.
Re: MotionBuilder
Posted: Thu Apr 10, 2008 2:02 pm
by fxrtst
Woohoo! Anytips? I just gave it a try and it seems to setup OK. The plugs are active and it gets a list of all the points but are listed at 0,0,0. When I play prerecorded optitrack data, it does not want to stream...just sits there. Any pointers to get it set up? I left the default IP address and double checked to see that they matched in Optitrack and Motionbuilder.
Will
Re: MotionBuilder
Posted: Thu Apr 10, 2008 3:14 pm
by VincentG
You will still need to go in and assign the individual points to the skeleton.
http://media.naturalpoint.com/optitrack ... uilder.wmv