forums.naturalpoint.com

Hi,
I am using 6 v100 cameras,but two of them seems to have some problem.Two leds in the IR ring doesn't lit like others.Its like these two leds is set to minimum intensity and the others to maximum,I've already try to lower the intensity and set to 15 again but nothing... In one camera the defective leds is located in the upper right corner and the other camera on the bottom left.

P.s :sorry for the bad English!

Can you send me a couple of camera shots, showing the ir rings?

sorry about the late response...

address doesn't seem to work

[img][IMG]http://i291.photobucket.com/albums/ll31 ... amera4.jpg[/img][/img]

It appears that there was just a fault in one of the LEds, which then broke the power path for the second one. By itself this will not effect the IR intensity of the cameras themselves, and will still preform correctly.