Page 1 of 1
No Data
Posted: Sat Jul 12, 2008 9:40 am
by Menessis
OK after changing a mother board I can't get my TIR3 to work. The best I could get was with ver- 3.13 where the device manager says it's installed and working but I just get "no data" ! When I tried the ver- 4.1.034 I got an error about a dll missing or corrupt. I even downloaded it a second time
I tried plugging it into 2 different ports. Left other usb devices unplugged.
Any Ideas for a fix?
Thanks
Menessis
Re: No Data
Posted: Mon Jul 14, 2008 9:46 am
by VincentG
Have you tried the device on another system?
Are you plugging in directly to the system, or are you using a hub?
Have you tried isolating the device on the USB ports?
Have you tried turn off any kind of power save feature for your USB ports?
In the "Device Manager" you can right click the "USB Root Hub"(s), that show, and then select properties. On the power management tab, uncheck the box that allows the computer to turn off the USB port to save power (i.e. uncheck the box). Sometimes that has an impact on the connectivity of the devices.
Re: No Data
Posted: Mon Jul 14, 2008 6:12 pm
by Menessis
Hi Vincent. Since writing this post I installed the newer software and have a whole new problem
So lets work on that one instead.
Menessis
Re: No Data
Posted: Tue Jul 15, 2008 9:00 am
by VincentG
Answered in another thread