Page 1 of 1
cannot select track clip pro
Posted: Tue Sep 09, 2008 3:06 pm
by wolfy
when i go into my profile and select edit it comes up as vector so i select track clip pro press enter but it stays on vector at the bottom (where it says it) if i press dot and ok it changes to dot why does it not do it with track clip pro..
and yes i am using track clip pro before you ask
Re: cannot select track clip pro
Posted: Tue Sep 09, 2008 3:12 pm
by VincentG
The vector expression, across the bottom of the main software indicates that it is using the vector expansion component of the software (3 dot tracking, and is not an indicator of the TrackClip (vector clip)/TrackClip Pro selection. Which both use the vector expansion, as far as tracking algorithm goes.
Re: cannot select track clip pro
Posted: Tue Sep 09, 2008 3:17 pm
by wolfy
ahh so evey thing is fine then thanks for your quick answer , i should have written first it would have saved me about 2 hours this evenig trying to get it to work...
Re: cannot select track clip pro
Posted: Tue Sep 09, 2008 3:25 pm
by VincentG
No issues....