forums.naturalpoint.com

Good evening all,

I have a TrackIR 3 and really enjoy it. Recently I built a new computer and got a new LCD monitor. With my old CRT monitor I just set the receiver on top of the monitor and was all set. On the new LCD monitor there is no place to put the receiver. I assume almost everyone else is using a LCD monitor so there must be a very simple solution to this problem. I just seem to be overlooking it. It is a problem of age and technology. (:>)

Thanks for the help,

Phil

Take a look at the monitor mount item at the bottom of the accessories page linked below. If you don't want to order it from us online you could probably pick up its equivalent in a local hardware store.

https://www.naturalpoint.com/trackir/02 ... ories.html

Thanks Birch! I already had that little plastic mount so what I did was bend the metal "T" mount to fit the monitor and put some double sided carpet tape on the two horizontal legs of the "T" and on the center plastic mount. Stuck it on the top of the monitor and so far it seems to be holding. We'll see how long it stays. May have to go to plan B whatever that might be. Now all I have to do is figure out how to get the thing up and running again. I assume you still have my registration dope if I need to get something re-registered? I may have any numbers on my old computer but will have to hook the thing up again to see. Thanks for the help, it is much appreciated. I'm going to order the headset adapter tomorrow. I've been using the hat with reflectors and think the little headset unit may be a much better deal.


Thanks again,

Phil

If you are looking for the vector codes, please email support, with your camera serial number, and issue that you are having. They can look up the information for you.