Page 1 of 1
CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Fri May 29, 2009 9:43 am
by bman2006
Good morning -
I thought I would point out a conflict with the current TIR5 beta software. I have set my pause button to the left thumb (button 4) of my mouse. My CH Yoke left / right toggle switch is conflicting with this button. TIR5 software thinks that this is also button 4.
TIR4 software does not have this issue. It maps the yoke buttons and mouse buttons independently.
Benjamin
Re: CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Fri May 29, 2009 1:35 pm
by VincentG
So it detects it as joystick 4, in the 5 software, regardless if it is the mouse or joystick
Re: CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Fri May 29, 2009 1:51 pm
by bman2006
It detects "mouse 4" in the 5 software both using mouse button 4 and CH yoke right toggle.
In short - software 5 thinks joystick 4 = mouse 4. However, if I set the pause key to Joystick 4 it does pick up as "joystick 4" and mouse 4 will not pause. It only conflicts when mouse 4 is set to pause... I can hit joystick 4 and it will also pause the TIR.
I just went back and double checked software 4 and mouse 4 = mouse 4.... joystick 4 = joystick 4. No double addressing.
Benjamin.
Re: CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Fri May 29, 2009 1:56 pm
by VincentG
Not using any joystick software, or macros assigned to mouse 4?
Re: CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Fri May 29, 2009 2:03 pm
by bman2006
Correct. No joystick or mapping software is installed. Windows manages all controllers.
I can get this to occur with simply the TrackIR software running an no other game apps active.
Just to reiterate, doesn't happen in software 4.1.37
Benjamin.
PS - Are you the same guy who did the "TrackIR explained" video?
Re: CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Fri May 29, 2009 2:05 pm
by VincentG
Nope
Re: CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Fri May 29, 2009 2:36 pm
by VincentG
What model of CH yoke are you using?
Try unchecking the trap option.
What mouse model are you using?
very strange, as my CH yoke isn't seeing the issue
Re: CH Yoke Button 4 conflicts with Mouse 4 - Beta 5
Posted: Sat May 30, 2009 9:20 am
by bman2006
I will check the trap option (not even sure what trap does...).
I am using the old CH yoke (from 2 years ago... not the eclipse).
Mouse = MX3200 Laser combo (keyboard + mouse)
I will keep you posted on the trap...