Page 1 of 1
Broken prong
Posted: Sat Jul 04, 2009 6:01 am
by Dys
One of my trackclip pro prongs broke where the three lights connect into the next bar thing... So the piece with the three lights just hangs out. Do I have to buy a whole new one or will you replace it?
Re: Broken prong
Posted: Mon Jul 06, 2009 4:27 am
by Spellbot5000
Wouldn't some epoxy do the trick?
Re: Broken prong
Posted: Mon Jul 06, 2009 12:18 pm
by VincentG
Please email support with your issue, as well as your camera serial number?
Re: Broken prong
Posted: Mon Jul 13, 2009 6:01 am
by XysteR
I had the exact same thing with my Track Clip Pro, but mine was like that on arrival, its held on with 2 extremely flimsy prongs, very poor, weak design. So much so i'm scared i might break it by even just putting my headphones down or taking them off. This was resolved by a replacement.