Page 1 of 1
How to change the units of Tracking Tools?
Posted: Mon Oct 26, 2009 6:50 pm
by memscad
Hello everyone, We are now try to use Tracking Tools with Trackd. The length and angle units of Tracking Tools streming are "meter" and "degree". But in Trackd, the length and angle units are "centimeter" and "radian". How to change it? Any advice is appreciate!
Re: How to change the units of Tracking Tools?
Posted: Tue Oct 27, 2009 12:02 pm
by VincentG
Answered in email
Re: How to change the units of Tracking Tools?
Posted: Tue Oct 27, 2009 6:19 pm
by memscad
Thanks for your email! But we still haven't solve our problem. This problem occurs as we using streaming module of trackd. It seems streaming module of trackd can not config the units of length and angle. But in trackd, units configuration are used quite often by setting DeviceOption. With Trackd default supported tracking system(ie. fastrack, flock of birds and etc), Trackd also provided corresponding DeviceOption to change the units of tracking data. Can you give us a solution to solve our problem?