Frame Rate sticking at 100fps when trajectorized
Posted: Tue Dec 01, 2009 9:33 am
Hello,
I'm capturing data for a 60fps project and would like some advice:
When I trajectorize captured data, the settings window it will always default to 100fps.
I'm change this to 60 and trajectorizing, then exporting the c3d for motion builder.
When the data is imported to motion builder however, it is showing as 100fps.
I can't find anything in the tutorials about where to set the original capture rate, or whether it's best to capture at a high rate and export at a lower rate? Somehow 100fps seems to be the overriding setting here, even though my playback settings in the bottom left corner of the viewport are set to 60fps.
I'd be grateful if you could clarify the best settings and procedure for capturing for a 60fps end rate - and also where to see / edit the true capture rate at the outset.
Many thanks. James
I'm capturing data for a 60fps project and would like some advice:
When I trajectorize captured data, the settings window it will always default to 100fps.
I'm change this to 60 and trajectorizing, then exporting the c3d for motion builder.
When the data is imported to motion builder however, it is showing as 100fps.
I can't find anything in the tutorials about where to set the original capture rate, or whether it's best to capture at a high rate and export at a lower rate? Somehow 100fps seems to be the overriding setting here, even though my playback settings in the bottom left corner of the viewport are set to 60fps.
I'd be grateful if you could clarify the best settings and procedure for capturing for a 60fps end rate - and also where to see / edit the true capture rate at the outset.
Many thanks. James