Pin out function for Custom breakout cable
Posted: Fri May 14, 2010 8:33 am
Hi,
I'm looking at the drawing for the V120 camera connector to make your own break out cable.
I know that the sync lines have an encoding on them that is specific to the sync operation of the cameras (i.e. its NOT a simple clock pulse).
I want to have a simple clock pulse from V120 provide signal to a custom device of ours. I was in a phone conference meeting and Jim Richardson stated that there is a pin on the V120 that puts out a basic square wave in time with the shutter or exposure or something.
Looking at the drawing I would guess that is Pin 3 AUX_OUT - can you verify this?
I'm looking at the drawing for the V120 camera connector to make your own break out cable.
I know that the sync lines have an encoding on them that is specific to the sync operation of the cameras (i.e. its NOT a simple clock pulse).
I want to have a simple clock pulse from V120 provide signal to a custom device of ours. I was in a phone conference meeting and Jim Richardson stated that there is a pin on the V120 that puts out a basic square wave in time with the shutter or exposure or something.
Looking at the drawing I would guess that is Pin 3 AUX_OUT - can you verify this?
