Page 1 of 1
Calibration Issues Arena 1.6.3
Posted: Fri Aug 20, 2010 8:08 am
by DonBurroni
Hello,
I installed the new version today 1.6.3, when I calibrate the cameras the wanding data is better than before, (more green lines) but when I calculate and apply the results I only get a poor result.
The cameras have not change position, before I would get exceptional result with the previous release?
Please help.
All the best
Don Burroni
Re: Calibration Issues Arena 1.6.3
Posted: Fri Aug 20, 2010 2:08 pm
by VincentG
How many cameras are you using?
What is your setup area?
Are you using a single point, or 3 marker wand?
What version were you using prior to 1.6.3?
Re: Calibration Issues Arena 1.6.3
Posted: Sat Aug 21, 2010 2:11 am
by DonBurroni
Hi Vinceent,
I have 12 cams, in the truss config.
the new 3 marker wand and I was using ARENA 1.6.100 Final - from May 28, 2010.
They worked all morning, I updated and now I only have poor calibrations, also I just found out the tabs are controles above the calibration engine.
I think you guys should release a manual at some point.
All the best
Don Burroni
Re: Calibration Issues Arena 1.6.3
Posted: Sun Aug 22, 2010 4:30 pm
by ProjectPalitoy
[quote=DonBurroni]Hi Vinceent,
I think you guys should release a manual at some point.
[/quote]
YES!
I know manuals in themselves can be quite an undertaking.... but it really is a major talking point amongst users, new and old...
Hey Don, where are you in the UK?
CC
Re: Calibration Issues Arena 1.6.3
Posted: Mon Aug 23, 2010 3:48 am
by DonBurroni
Hi guys uninstalled arena, reinstalled, rebooted twice and now I'm getting great/Exellent results.
Thanks all the best
Burroni