forums.naturalpoint.com

well once we start calibrating none of the cameras can see the calibration square...in order for the other cameras to see it we have to tilt it...once the calibration finishes...the cameras come out tilted on the plane...is there a way to rotate the cameras after the calibration is finished on the plane? and also is there a way to not have to tilt the calibration square?

thanks

Having to "tilt" it is going to depend on how you have the cameras setup/and or aimed within the setup itself.

Which OptiTrack application are you running?

You can change the translation in the x/y/z, but not the yaw/pitch roll, within the TT software