forums.naturalpoint.com

Dear Support
I am tryng to setup a good profile for FSX, I am stuck on try to position my head on bottom Right side.
If with my head i try to going in negative Yaw it's fine as long I pitch in negative way it start shaking in Roll and Yaw mode and also it dosen't keep the position.
I tried diffrent profile and play with them even the Seth one, but at the end i always get the same result.
I also fix with a doubleside tape the TrakIr and positioned in front so the three refractor get always on center.
The funny things if I Pitch up from left to the right everything is fine, so I can very precise on the overhead worload.
I have the TrackIR4 with V5 software and the hat with Track clip on windows 7 64 bit even o a machine with windows XP 32.
Some time the V5 software is crashing with this event
Nome dell'applicazione che ha generato l'errore: TrackIR5.exe, versione: 5.0.0.300, timestamp: 0x4a6fa655
Nome del modulo che ha generato l'errore: nvoglv32.DLL, versione: 8.17.12.5896, timestamp: 0x4c378f09
Codice eccezione: 0xc0000005
Offset errore 0x0063dcb1
ID processo che ha generato l'errore: 0xe30
Ora di avvio dell'applicazione che ha generato l'errore: 0x01cb6a2498a8d740
Percorso dell'applicazione che ha generato l'errore: C:\Program Files (x86)\NaturalPoint\TrackIR5\TrackIR5.exe
Percorso del modulo che ha generato l'errore: C:\Windows\system32\nvoglv32.DLL
ID segnalazione: da5946c0-d617-11df-9504-00044b019cd8
Thank you for any help.
Fabrizio

So the software control when looking down starts to behave erratically?

Is the metal TrackClip at the same height as the TrackIR camera?

How far away are you, from the camera?

[quote=NaturalPoint - Vincent]So the software control when looking down starts to behave erratically?
[/quote]
yes

[quote=NaturalPoint - Vincent]
Is the metal TrackClip at the same height as the TrackIR camera?
[/quote]
Quite 10 cm lower but the three clip are always on the screen, and when you look down they are perfectly visible due the position.

[quote=NaturalPoint - Vincent]
How far away are you, from the camera?
[/quote]
around 80cm

Thank you
fabrizio

What happens if you uncheck the True View option?

Sorry I haven't told I am using with uncheck True View because i need to use with EZCA in FSX.

Do you see the issue, when not using EZCA?

yes

Do you see it only in FSX, or within the IR software as well?

IR software as well.

Sorry but what about this problem any solution or i have to buy the new version to make it working?