Hi:
I'm upgrading from a TIR to a TIR Pro 3. I have the latest software and drivers set up and working great. Can I simply unplug the old unit and plug in the new one? Or would you suggest I reinstall the software as well?
Thanks
New TIR 3 Pro
Re: New TIR 3 Pro
hassata,
A lot will depend on the drivers that you have currently installed. You say you have the latest.
If you have version 3.10 and above you will have no problems, however you will still have to run through a hardware install wizard, because of the different hardaware, this should present no problems.
If you have earlier software installed then I suggest that you run through the un-install first, before installing the later software.
It is also important as with any hardware install, that you set a restore point if using Win XP.
If you have any problems or are unsure please e-mail me and I will talk you though the procedure.
A lot will depend on the drivers that you have currently installed. You say you have the latest.
If you have version 3.10 and above you will have no problems, however you will still have to run through a hardware install wizard, because of the different hardaware, this should present no problems.
If you have earlier software installed then I suggest that you run through the un-install first, before installing the later software.
It is also important as with any hardware install, that you set a restore point if using Win XP.
If you have any problems or are unsure please e-mail me and I will talk you though the procedure.