When one tries to make a custom profile using dead zones through the "edit points", there seems to be a problem with it saving to a particular X or Y axis...Also the when one increases the edit points, the centre deadzone graph takes on a weired spike in the middle shape instead of a flattened in the middle one(?)
So is it possible in my case to have a X axis speed of 15 with a deadzone edit points of 2 and a Y axis speed of 30 with a deadzone edit points of 2?
If I save my settings as above, the edit points allways seem to revert back to 0 ?
Any help would be apreciated.
Btw, this TrackIR is the best thing since sliced bread. Thx Natural point chaps.
Problem with trying to save deadzones etc
Re: Problem with trying to save deadzones etc
quote:When one tries to make a custom profile using dead zones through the "edit points", there seems to be a problem with it saving to a particular X or Y axisDo you have the Axis link button enabled? (This is the button between the "X" and the "Y" Axis Edit Selection - it will bind the two together and mirror the changes.)
quote:
...Also the when one increases the edit points, the centre deadzone graph takes on a weired spike in the middle shape instead of a flattened in the middle one(?)Is the "Group Edit Points" checkbox enabled? If it is not, then only one edit point at a time is adjusted. Therefore if you have selected Edit Point 1 to edit, and change the value, only the center point on the graph will rise or fall (could produce the spike you saw).
quote:So is it possible in my case to have a X axis speed of 15 with a deadzone edit points of 2 and a Y axis speed of 30 with a deadzone edit points of 2? I am not sure I entirely understand.
Do you mean this :
All of the X Axis edit points are set to a value of 15, except for edit points 0 and 2, which are set to value 0 (producing a deadzone at the center)
and
All of the Y Axis edit points are set to a value of 30, except for edit points 0 and 2, which are set to value 0 (producing a deadzone at the center)?
I set up a profile with these settings, here is a screenshot :
quote:If I save my settings as above, the edit points allways seem to revert back to 0 ? Check above about the "Group Edit Points"
Hope this helps some.
quote:
...Also the when one increases the edit points, the centre deadzone graph takes on a weired spike in the middle shape instead of a flattened in the middle one(?)Is the "Group Edit Points" checkbox enabled? If it is not, then only one edit point at a time is adjusted. Therefore if you have selected Edit Point 1 to edit, and change the value, only the center point on the graph will rise or fall (could produce the spike you saw).
quote:So is it possible in my case to have a X axis speed of 15 with a deadzone edit points of 2 and a Y axis speed of 30 with a deadzone edit points of 2? I am not sure I entirely understand.
Do you mean this :
All of the X Axis edit points are set to a value of 15, except for edit points 0 and 2, which are set to value 0 (producing a deadzone at the center)
and
All of the Y Axis edit points are set to a value of 30, except for edit points 0 and 2, which are set to value 0 (producing a deadzone at the center)?
I set up a profile with these settings, here is a screenshot :
quote:If I save my settings as above, the edit points allways seem to revert back to 0 ? Check above about the "Group Edit Points"
Hope this helps some.