12F_Soron,
If anyone else is also trying to delete these keys...
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum\USB\Vid_0547c&Pid_1002, HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum\USB\Vid_0547c&Pid_0008
You will need to check that first you have admin privs.
If the keys will still not delete you will have to go into the "Device Manager" and delete/un-install the USB device this will most likely be "Unknown Device".
Unplug your unit and re-boot your computer, then check for these keys.
You should now be good to re-install your NaturalPoint software.
If anyone else is having problems please contact me.
[ May 14, 2004, 01:04 PM: Message edited by: Wayne ]
Software cannot be connected with the device
Re: Software cannot be connected with the device
@ Wayne: Yes. that was correct English!
greets!
P.S.:But, the new driver is not more better as 2.12
[ May 17, 2004, 03:49 AM: Message edited by: Dimi3 ]
greets!
P.S.:But, the new driver is not more better as 2.12
[ May 17, 2004, 03:49 AM: Message edited by: Dimi3 ]
-
WTE_Flyingfox
- Posts: 6
- Joined: Fri Dec 12, 2003 5:00 am
Re: Software cannot be connected with the device
hi
my problem is that i installed 3.10 and it found regitry keys from old install 3.1 i think [good cause i do not know and will not try to delete keys in regitry ] now when pc boots up it finds new usb devce however when i try to point to the drivers it [ the drivers dont show up in the screen so i can pick them ]
your thoughts please
my problem is that i installed 3.10 and it found regitry keys from old install 3.1 i think [good cause i do not know and will not try to delete keys in regitry ] now when pc boots up it finds new usb devce however when i try to point to the drivers it [ the drivers dont show up in the screen so i can pick them ]
your thoughts please
Re: Software cannot be connected with the device
WTE_Flyingfox,
Please read my post above.
Please read my post above.
-
WTE_Flyingfox
- Posts: 6
- Joined: Fri Dec 12, 2003 5:00 am
Re: Software cannot be connected with the device
need help please
could some kind soul give me a walkthrough on how to delete those keys please as i have no idea how to [ never used registry before ]
question ?
are the 3.10 drivers surposed to delete those reg keys
or are we surposed to do it manually oursleves
could some kind soul give me a walkthrough on how to delete those keys please as i have no idea how to [ never used registry before ]
question ?
are the 3.10 drivers surposed to delete those reg keys
or are we surposed to do it manually oursleves
Re: Software cannot be connected with the device
WTE_Flyingfox,
First of all I need to know the operating system that you are using. (I will assume you have XP)
If you are upgrading to the 3.10 drivers ensure that you connect TrackIR to the same USB port.
If you have already connected TrackIR to a different USB port then this is why this can happen, XP especially remembers each USB port as a seperate gateway.
Connect your TrackIR to each port and un-install from the "Device Manager" this should remove those keys.
If all fails then carry out your "Restore" (if using XP), and restore to before the upgrade and start again and use the same USB port.
If you are still having problems with these keys then let me know either here or dropping me an e-mail. I will be more than happy to to talk you through the reg key removal.
First of all I need to know the operating system that you are using. (I will assume you have XP)
If you are upgrading to the 3.10 drivers ensure that you connect TrackIR to the same USB port.
If you have already connected TrackIR to a different USB port then this is why this can happen, XP especially remembers each USB port as a seperate gateway.
Connect your TrackIR to each port and un-install from the "Device Manager" this should remove those keys.
If all fails then carry out your "Restore" (if using XP), and restore to before the upgrade and start again and use the same USB port.
If you are still having problems with these keys then let me know either here or dropping me an e-mail. I will be more than happy to to talk you through the reg key removal.
-
WTE_Flyingfox
- Posts: 6
- Joined: Fri Dec 12, 2003 5:00 am
Re: Software cannot be connected with the device
thank you for your prompt reply
my os is win2000
will need step by step instructions in registry
when new divice wizard discovers new device
i try to point to 3.30 drivers it [ pc ] can not see them thus i can not finish installing track ir
my os is win2000
will need step by step instructions in registry
when new divice wizard discovers new device
i try to point to 3.30 drivers it [ pc ] can not see them thus i can not finish installing track ir
Re: Software cannot be connected with the device
WTE_Flyingfox,
Connect your unit to each USB port in turn, then go into "Device Manager" and delete the "Unknown Device" this should remove those two keys.
Please let me know if you are a little unsure, I would be happy to talk through this procedure on the phone.
Connect your unit to each USB port in turn, then go into "Device Manager" and delete the "Unknown Device" this should remove those two keys.
Please let me know if you are a little unsure, I would be happy to talk through this procedure on the phone.
-
WTE_Flyingfox
- Posts: 6
- Joined: Fri Dec 12, 2003 5:00 am
Re: Software cannot be connected with the device
hi
just thought i d let you know think i know why tack ir not working tried usb [ change ing which usb input i put into i tried all of them
i think the problem is in the registry
i think my thrustmaster afterburner 2 ff has effected my registry cos when i point to the drivers [track ir ] it pionts to thrusmaster as a sort of default i tried to uninstall the thrustmaster i got a blue screen so until i upgrade my system i will have to live without my track ir
i would like to thank all of you for your help
fox out
just thought i d let you know think i know why tack ir not working tried usb [ change ing which usb input i put into i tried all of them
i think the problem is in the registry
i think my thrustmaster afterburner 2 ff has effected my registry cos when i point to the drivers [track ir ] it pionts to thrusmaster as a sort of default i tried to uninstall the thrustmaster i got a blue screen so until i upgrade my system i will have to live without my track ir
i would like to thank all of you for your help
fox out
-
HarryLeBlanc
- Posts: 4
- Joined: Mon Jun 28, 2004 5:00 am
- Location: Minnesota, MN
Re: Software cannot be connected with the device
I'm having the same problem -- my TrackIR 1 isn't installing correctly. But I'm pretty sure it's not due to old registry keys. This is a brand new machine with a clean install of win xp pro, and the first time I plugged the device in, I got the following error:
There was a problem installing this hardware:
USB Device
An error occurred during the installation of this device
A service installation section in this INF is invalid.
The cd was for version 2.01, which was what came with the device. FWIW, it worked perfectly a week and a half ago before my old computer died; it smells like a driver bug to me.
Is it possible to download a more recent firmware driver for this device? The download section only has the userspace app, which does not recognize the device.
Help!
Harry LeBlanc
There was a problem installing this hardware:
USB Device
An error occurred during the installation of this device
A service installation section in this INF is invalid.
The cd was for version 2.01, which was what came with the device. FWIW, it worked perfectly a week and a half ago before my old computer died; it smells like a driver bug to me.
Is it possible to download a more recent firmware driver for this device? The download section only has the userspace app, which does not recognize the device.
Help!
Harry LeBlanc