Okay, I just re-settled into my desk area again and set up my TrackIR. Installed the software, put in Vector code, and...well, it won't track. The green light comes on, the screen reads the reflective matieral on the hat, but the guages won't move.
The question I have is do I need the vector clip for it to work? And if it is that, where can I purchase one? I'm 200 miles away from home here at college and I would rather purchase a new one since digging through my old room would take decades.
My TrackIR Won't Track
Re: My TrackIR Won't Track
You will need all 3 reflectors on the clip for 6DoF to work. Does the 2Dof work ok though?
Re: My TrackIR Won't Track
There is a couple of things that you could try (if you have not already.)
Unplug the TIR and reboot, then plug the unit into a different USB port on its own.
Make sure that Dot is selected in the profile because if Vector is selected with your code running the software would be expecting 3 reflections not the one that is being used.
Apart from a uninstall and reboot and install in a differnt directory path I am not sure what else to do but drop Rick an email with your unit number, real name and forum nic along with full details (give him the link to here if you want as well).
Good Luck.
Unplug the TIR and reboot, then plug the unit into a different USB port on its own.
Make sure that Dot is selected in the profile because if Vector is selected with your code running the software would be expecting 3 reflections not the one that is being used.
Apart from a uninstall and reboot and install in a differnt directory path I am not sure what else to do but drop Rick an email with your unit number, real name and forum nic along with full details (give him the link to here if you want as well).
Good Luck.
Re: My TrackIR Won't Track
my 2DOF doesn't work, even if I just enable up/down left/right. The screen will show the green dot on the display screen, it'll move fluidly, but the gauges nor the head will move.