i have 12 v100 cams
(6 of the first, and 6 of the second generation)
on two optihuds
the distance from camera to capture center was about 13 feet.
for the first time i wanted to calibrate with the new 3point wand, but it hardly was seen by the cameras. only when i waved directly to them and moved closer.
it did hardly work at all, and ended up with 12 times poor.
since the markers are much smaler then on the 1point wand,
i did retry with the old wand and calibration method.
but still, when i wave to one tripod, the oposite one does hardly see anything from that.
(and yes, i held the wand upwards and did not stand in the way)
its just like the cameras cant see as far anymore as before.
like if the leds are loosing illuminating power through the years.. can that be ?
also i still have cameras just shutting down during capturing.
first everything is there, but a few captures later, suddenly 1-3 cameras dont record points anymore..
i hoped the upgrade from d-link to optihud and from arena 1.4 to 1.6.3 might make it better.. but it didnt.
