CFS3
-
Charlie251
- Posts: 955
- Joined: Fri Jan 03, 2003 5:00 am
- Location: Melbourne, Florida
Re: CFS3
Hi Trap,
Instead of regurgitating it all here, go to www.virtualflightproductions.com and click on the Vector Tutorial under the Reviews section.
While the software is different between the versions, they act the same in regards to customizing the speed curve.
Go down to the paragraph above the CURVE EDITOR picture and read it. It will give you a very good idea on how to edit the points individually to make a custom curve.
If you still have questions after that, post back here and I will do my best to answer. It has been many weeks since I have used the v3 software so I may struggle with instructions.
PS: The old profiles created in version 3 will not work with the Vector Expansion software. You will have to start from scratch. But, I encourage you to figure out how to do it in version 3 so you will be on top of things the day you get the new stuff.
[ December 07, 2004, 07:58 PM: Message edited by: Charlie ]
Instead of regurgitating it all here, go to www.virtualflightproductions.com and click on the Vector Tutorial under the Reviews section.
While the software is different between the versions, they act the same in regards to customizing the speed curve.
Go down to the paragraph above the CURVE EDITOR picture and read it. It will give you a very good idea on how to edit the points individually to make a custom curve.
If you still have questions after that, post back here and I will do my best to answer. It has been many weeks since I have used the v3 software so I may struggle with instructions.
PS: The old profiles created in version 3 will not work with the Vector Expansion software. You will have to start from scratch. But, I encourage you to figure out how to do it in version 3 so you will be on top of things the day you get the new stuff.
[ December 07, 2004, 07:58 PM: Message edited by: Charlie ]