HI
I have an optitrack and i want to input a trigger to the optihub using external sync in.
Can someone have information about the jack plug. is it a mono? I suppose ground is near the wire and + at the extremity?
Do you think 5v and serial 200ohms resistor would be enough?
I don't want to make mistake !!!
Thanks
External sync in information
Re: External sync in information
Hi, Did you ever figure this out?
-
- NaturalPoint Employee
- Posts: 720
- Joined: Mon Jan 19, 2015 11:52 am
Re: External sync in information
Hi Cimi,
The External Sync In and External Sync Out connectors, on the OptiHub, should be BNC.
https://en.wikipedia.org/wiki/BNC_connector
I hope this helps,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
support@optitrack.com
The External Sync In and External Sync Out connectors, on the OptiHub, should be BNC.
https://en.wikipedia.org/wiki/BNC_connector
I hope this helps,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
support@optitrack.com