This was my post:
Does any tech out there know how to edit out (or is it possible to edit out) the upside down rearward view in Trackir v2.01b. I dont fly online and I like being able to look at my 6 oclock but dont like the wierd view in my setup. Any help appreciated.
I already have v2.01 final which works fine but you cannot get a true 6 oclock view which I know from experience in flying real airplanes that my neck can turn as far as the rear view in v2.01 final and by shifting my eyes I can see my 6 oclock(vertical stabilizer) so if I could get rid of the upside down view in v2.01b I feel it would be closer to real.
I didnt know this was such an issue until today. Can anyone here help me?
il2 forum locked me out today!
Re: il2 forum locked me out today!
whurst1,
Load your profile, go to the Motion tab, click on Absolute Mode and try creating dead zones at the extremes of the Y axis by reducing the speed to zero at edit points 40 and 50. Experiment a little till the view slows down or stops before you get to the 6 o'clock position. Be sure to decouple the X-Y axes by clicking on the blue chain link in the "Edit a Motion Axis" line and choose the Y Axis. Other than that it's just a matter of limiting your up and down head movement.
[ April 29, 2003, 03:30 PM: Message edited by: Phalcon51 ]
Load your profile, go to the Motion tab, click on Absolute Mode and try creating dead zones at the extremes of the Y axis by reducing the speed to zero at edit points 40 and 50. Experiment a little till the view slows down or stops before you get to the 6 o'clock position. Be sure to decouple the X-Y axes by clicking on the blue chain link in the "Edit a Motion Axis" line and choose the Y Axis. Other than that it's just a matter of limiting your up and down head movement.
[ April 29, 2003, 03:30 PM: Message edited by: Phalcon51 ]
Re: il2 forum locked me out today!
Thanks Phalcon51! I will give that a try.