TIRconnected, but not into P3D v3 / aircraft

[cuevision]

Hello,

I use TIR with fun for a lot of years now. Never had any problems, until today. Yesterday it functioned well. However during flight my P3D crashed. After restarting I keep on getting the message that simconnect not respond for 50 sec. I had this message before and remembered Simconnect with EZCA caused it. So what I did is removing EZCA (EZDOK). I deintalled both simconnnect programs from P3D and reinstalled them.

After starting up P3D and TIR does this automatically, the message of Simconnect not working was gone.

TIR started up ok. In the TIR scfreen I see that it respond on my headmovement nice. But whatever I tried, this movement is not brought up to my planes. I noticed from the right lower corner that the left LED does not light up (Hovering on it says: TrackIR enhanced (game enabled))

I was thinking about the integration of TIR into EZCA. Could it been caused that before I removed EZCA, I did not unchecked TIR in the EZCA configuration?

I am looking forward to a reply.

Thanks and regards,
Ed

[cuevision]

Hello everybody!

In the meanwhile solved. I reinstalled it and again worked like a charm. Ezca must have caused the problems I had.

Thanks and regards,
Ed