Streaming between Tracking tools and motionbuilder

[cuterabbit]

Hi, I am new in optitrack and streaming in any application. I have some problem of streaming from tracking tools to motionbuilder. I can see only last trackable. It doesn't show the other trackable. For example I create two trackables. TT show I have created two groups of trackable. After I finish the step of streaming between TT and motionbuilder. I choose trackable1 in motionbuilder in optitrack markerset. Finally, I can't see any marker of trackable1. When I choose trackable2, motionbuilder can show the markerset of this trackable.
My TT version is 2.5 and motionbuilder version is 2011.

[NaturalPoint - Mike]

Hello -

At current, the motionbuilder plugin is only designed for a single rigid body. You may be able to load multiple instances of the plugin, one for each rigid body, but as of yet this is untested.

[cuterabbit]

Hello Mike

Thanks for your answer.
I have more question. Motionbuilder can show only single rigid body, in case if I have more than one rigid body. Can I choose each rigid body to show in view plane and How to do that.

[NaturalPoint - Mike]

I wish I could answer this for you. Since the plugin will only stream a single rigid body, that's where the extent of my experience ends. You may have to ask Autodesk support.

[cuterabbit]

Thank you Mike

[cuterabbit]

Thanks Mike