forums.naturalpoint.com

Hi, I am new in optitrack and streaming in any application. I have some problem of streaming from tracking tools to motionbuilder. I can see only last trackable. It doesn't show the other trackable. For example I create two trackables. TT show I have created two groups of trackable. After I finish the step of streaming between TT and motionbuilder. I choose trackable1 in motionbuilder in optitrack markerset. Finally, I can't see any marker of trackable1. When I choose trackable2, motionbuilder can show the markerset of this trackable.
My TT version is 2.5 and motionbuilder version is 2011.

Hello -

At current, the motionbuilder plugin is only designed for a single rigid body. You may be able to load multiple instances of the plugin, one for each rigid body, but as of yet this is untested.

Hello Mike

Thanks for your answer.
I have more question. Motionbuilder can show only single rigid body, in case if I have more than one rigid body. Can I choose each rigid body to show in view plane and How to do that.

I wish I could answer this for you. Since the plugin will only stream a single rigid body, that's where the extent of my experience ends. You may have to ask Autodesk support.

Thank you Mike

Thanks Mike