Hi all,
I own Trackir 5 from a couple years and everything was good with Win7 64, Fsx & Fs9 until some days ago.
Suddenly, could be after a reg cleaning, when I start the Tir and than launch Fsx or 9, camera goes in a red "pelting" and Tir stopped working in a while.
Ok nothing wrong... I un-installed Tir software, reg clean (CCleaner), downloaded new release 5.2 final, installed, rebooted, device connected to install drivers that goes ok, rebooted again.
Here something strange happens: if I want to use Tir with simulators, I have to plug it in usb port every time I boot the pc.
If I leave Tir connected to the usb (2.0) port and boot or reboot the pc, when I start Tir software the device perfectly works, but just starting Fsx or Fs9 with or without Active Sky Evolution, the camera goes red and Tir stop working...
At the moment after closing a Win session, I disconnect the device also. When I have to start a new session, I start FSX or 9 with Ase first and then I connect Tir and start his software also.
In this mode everything works...
Any ideas?
Many thanks