How do I get rid of the deadzone?

[FrankTheSpank]

I have been looking everywhere, done searches and I cannot for the life of me find out how to completly eliminate the deadzone in TrackIR.

Is there some option I un-check or what?

Thank you for any help.

[Barred]

Use linear mode. Then you will have no dead zone and the relationship of head movement to ingame will remain constant.

Try downloading my profile for the Trackclip from http://www.naturalpoint.com/trackir/04- ... files.html and edit the profile so that the vector is seen instead of the clip. Whilst you are in edit mode turn on roll

Merry Christmas.

[tcgeo]

Hi FrankTheSpank

I�m not sure if this will help with completely eliminating the dead zone like you�re after. But, if you start in the Profiles tab then go to: Edit, Motion tab, then to Edit Yaw, in the curve editor window, choose a setting from the acceleration window or choose custom and adjust the curve manually. I think you can pretty much eliminate any dead zones this way.

Hope this helps.

Good Flying,

George

[VincentG]

Both very good tips.

Did these help out?