Page 1 of 1
How do I get rid of the deadzone?
Posted: Sat Dec 23, 2006 7:59 pm
by FrankTheSpank
I have been looking everywhere, done searches and I cannot for the life of me find out how to completly eliminate the deadzone in TrackIR.
Is there some option I un-check or what?
Thank you for any help.
Re: How do I get rid of the deadzone?
Posted: Sun Dec 24, 2006 5:21 am
by Barred
Use linear mode. Then you will have no dead zone and the relationship of head movement to ingame will remain constant.
Try downloading my profile for the Trackclip from
http://www.naturalpoint.com/trackir/04- ... files.html and edit the profile so that the vector is seen instead of the clip. Whilst you are in edit mode turn on roll
Merry Christmas.
Re: How do I get rid of the deadzone?
Posted: Sun Dec 24, 2006 12:30 pm
by tcgeo
Hi FrankTheSpank
I�m not sure if this will help with completely eliminating the dead zone like you�re after. But, if you start in the Profiles tab then go to: Edit, Motion tab, then to Edit Yaw, in the curve editor window, choose a setting from the acceleration window or choose custom and adjust the curve manually. I think you can pretty much eliminate any dead zones this way.
Hope this helps.
Good Flying,
George
Re: How do I get rid of the deadzone?
Posted: Tue Dec 26, 2006 12:23 pm
by VincentG
Both very good tips.
Did these help out?