Upgrade error message - Could not connect with a SmartN
Posted: Wed May 13, 2009 10:05 am
I'm running SmartNav 3 version 2.14.
I have been trying to upgrade to the newest software.
I've followed all of the steps like deleting the old and unplugging before starting again with the new.
the message I get when I try to restart is:
"Could not connect with a SmartNav camera! Mouse control will be disabled until a SmartNav camera is plugged in."
What do I or should I be doing?
Thanks!
jim
I have been trying to upgrade to the newest software.
I've followed all of the steps like deleting the old and unplugging before starting again with the new.
the message I get when I try to restart is:
"Could not connect with a SmartNav camera! Mouse control will be disabled until a SmartNav camera is plugged in."
What do I or should I be doing?
Thanks!
jim