Arena Skeleton and tracking Errors. Can they be fixed?
Posted: Mon Jul 11, 2011 10:52 am
Hello,
I have a couple different problems and I would greatly appreciate any help you can offer.
I have collected motion data using an 11 camera setup on martial artists collecting at 100 fps. The speed of these Sifu creates tracking problems and it was not uncommon for a particular anatomic segment (such as the right arm)to turn red. The tracking system was unable to identify where that particular segment was despite the markers being visible on the screen. I tried to figure out a way to manually assign these marker locations. I selected the Assign Object button and instead of manually assigning the marker locations it added more markers to the skeleton. I left arena without saving, however, the skeleton was automatically saved. Thus every time I load the project file there are more markers assigned to this segment. (in my case... The head should have 3 markers I apparently added 5 markers to the head segment and it now shows a total of 8 markers when I select the assign object button)
Is there a way to fix my screw up and remove the additional markers I accidently assigned to the segment? (I originally used the 38 marker skeleton wizard)Also is there a way to manually select and assign a particular marker as one of the markers used in the skeleton?
Any information on removing the markers I obliviously added to the skeleton would be greatly appreciated!
Jeet Kune Do Biomechanics
I have a couple different problems and I would greatly appreciate any help you can offer.
I have collected motion data using an 11 camera setup on martial artists collecting at 100 fps. The speed of these Sifu creates tracking problems and it was not uncommon for a particular anatomic segment (such as the right arm)to turn red. The tracking system was unable to identify where that particular segment was despite the markers being visible on the screen. I tried to figure out a way to manually assign these marker locations. I selected the Assign Object button and instead of manually assigning the marker locations it added more markers to the skeleton. I left arena without saving, however, the skeleton was automatically saved. Thus every time I load the project file there are more markers assigned to this segment. (in my case... The head should have 3 markers I apparently added 5 markers to the head segment and it now shows a total of 8 markers when I select the assign object button)
Is there a way to fix my screw up and remove the additional markers I accidently assigned to the segment? (I originally used the 38 marker skeleton wizard)Also is there a way to manually select and assign a particular marker as one of the markers used in the skeleton?
Any information on removing the markers I obliviously added to the skeleton would be greatly appreciated!
Jeet Kune Do Biomechanics