Invalidate Markers Below Floor recommendation
Invalidate Markers Below Floor recommendation
In your next version of Motive, it would be nice if the "Invalidate Markers Below Floor" feature is only applied if a new ground plane has been set since the last calibration. Often when you re-calibrate, the left over ground plane will result in the calibration square markers being in-validated. Not a huge deal, but I actually thought the calibration was failing for a long time until I realized this was the issue.
-
- NaturalPoint Employee
- Posts: 718
- Joined: Mon Jan 19, 2015 11:52 am
Re: Invalidate Markers Below Floor recommendation
Hello bteitler,
Thank you for this feedback. We may not have encountered this, and I agree that it could be improved to avoid confusion.
I will be verifying this behavior and will forward this recommendation to our development team.
Best regards,
Steven
--
Steven Andrews
OptiTrack | Customer Support Engineer
Thank you for this feedback. We may not have encountered this, and I agree that it could be improved to avoid confusion.
I will be verifying this behavior and will forward this recommendation to our development team.
Best regards,
Steven
--
Steven Andrews
OptiTrack | Customer Support Engineer