Invalidate Markers Below Floor recommendation

[bteitler]

In your next version of Motive, it would be nice if the "Invalidate Markers Below Floor" feature is only applied if a new ground plane has been set since the last calibration. Often when you re-calibrate, the left over ground plane will result in the calibration square markers being in-validated. Not a huge deal, but I actually thought the calibration was failing for a long time until I realized this was the issue.

[steven.andrews]

Hello bteitler,

Thank you for this feedback. We may not have encountered this, and I agree that it could be improved to avoid confusion.

I will be verifying this behavior and will forward this recommendation to our development team.

Best regards,
Steven
--
Steven Andrews
OptiTrack | Customer Support Engineer